What is the NANDFlasher?

THE FIRST PROFESSIONAL TOOL FOR ALL YOUR XBOX 360 HOMEBREW NEEDS !!

The nandflasher is basically a JTag device that lets you read and write to the X360 NAND.
This requires an Exploitable console. Hmm, is my console xploitable?
Well if you have a dash kernel before 8xxxx and the console was manufactured before Jun 18, 2009, then you most likely can use this device.

Compatible with Nandpro v2.0d for reading and writing to all mainboard versions (Xenon, Falcon, Zephyr, Opus, & Jasper) on consoles that are xploitable, meaning kernel 7xxx or lower, manufactured before Jun 18, 2009 and has not been to a a MS repair center since June 12, 2009.

Features:

• Professionally manufactured PCB
• Standard USB port
• Power LED is green for normal operation
• Works will all flash sizes
• SUPER SIMPLE INSTALL !!

More Info:

Did your 360 get banned in this wave of bans? HD install not working? Gamertag and saves keep corrupting? This is how to fix this (aka ‘uncrippling’).

To start with, you’ll need to know a few things. This is going to involve a small amount of soldering, and a little knowledge of Nandpro and Hex (and a lot of patience if you’ve got a 256/512mb Jasper). Also, and an important point: THIS WILL NOT UNBAN YOUR 360 – ALL THIS DOES IS TO ALLOW TRUSTED CONTENT ON YOUR CONSOLE. That out of the way, lets get on with the tut.

Part 1: Cable creation, and hooking it up:

You will need:

1. DB25 25-way male plug + wires – or the male end from a printer cable leave the wires attached, cut off the female end.
2. 5 X 100 ohm resistors.
3. 1 X Switching diode.
4. Soldering iron, flux and solder.
5. A PC running Windows (32bit XP worked for me), and with a Parallel Printer Port.
6. NandPro – Download HERE
7. Hex Workshop – Dwnload here: http://www.hexworkshop.com/

(more…)